[Tim1300Turbo]

Hello Tim,

Crown and bevell gear is a matching set with one Number depending on the axle ratio.

There is a 27/7 Ratio (A 443 330 04 39) and a 25/8 Ratio (A443 330 05 39)

both were used only with the MB-trac heavy series BM443. They are not compatible with any Unimogs.

But "reproductions" may be available here in the Forum.

Check here: https://www.trac-technik.de/Forum/showth...?tid=28310&pid=172772#pid172772

but if you get lucky, only the splines from the driveshaft are stripped?

It is part number A442 337 00 10 but again was used only on these MB-trac.

best regards
Wulf

Thank you for the information and part numbers,Ive pulled the torque tube off and found that the Pinion has snapped. The splines are all good and not twisted, I cant understand how this has happened. Is it possible to only fit a new pinion without splitting the diff and renewing the crownwheel as well.

Regards,
Tim